Katalóg svietidiel LABRA 2022

multisystem

7.2214 End Cap (no hole)

7.2215EG Corner Joint 90° NT/ZW

7.2460EG Stik On 35x2

7.2222EG Shift On 3x1

7.2212EG Corner connector

7.2249EG Corner connector - Flexible

7.2201EG Track NT 200cm

7.2470EG Line In Points 286

The ceiling-to-wall angle joint is created by butt jointing two NT profiles together. No additional mechanical coupling is required. Angle connection in one plane requires a sepa rate element – a 90° angle connector, which is different for NT and WP profiles. The power supply box can be mounted at either end of the system. It must be connected to the power terminal using cables. Each box comes with the appropriate power supply – check the part numbers. Remember to install the end caps. For NT / WP profiles, the power cable can be inserted through a hole drilled in the profile bottom. An end cap with a 10 mm diameter hole will be useful if the power cable is inserted at the end of the profile, for example when suspended profiles are used.

7.2210EG End Feed

9.2462 / 9.2463 9.2464 / 9.2465 Driver + Box NT

126